User Manual

RKE Programming Instructions
PLEASE READ CAREFULLY BEFORE TRYING! IF AT ANY TIME YOU
MAKE A MISTAKE, START AND STOP YOUR CAR, EXIT THE
VEHICLE AND START OVER. THE REMOTE CAN BE ONLY
PROGRAMMED WITH A MASTER KEY
1. SIT IN CAR WITH DOORS AND WINDOWS CLOSED.
2. LOCK DOORS WITH POWER DOOR LOCK SWITCH ON
DRIVER'S DOOR.
3. PUT IN AND PULL OUT KEY FROM IGNITION APPROX. 8
TIMES OR UNTIL YOU SEE THE HAZARD/TURN SIGNAL
LIGHTS FLASH.(older models lights may flash after 4 or 5
times) YOU NEED TO DO THAT IN LESS THEN 10 SEC
4. WHEN HAZARD LIGHTS FLASH (ON 2005 AND NEWER
MODELS THE GAUGE NEEDLES MAY JUMP A LITTLE
INSTEAD) , PUT KEY IN IGNITION AND TURN TO THE ACC
POSITION.(when your hazard lights flash your car is
sending a signal to be received by the remote)
5. PRESS LOCK BUTTON ON THE NEW REMOTE
TRANSMITTER, LIGHTS SHOULD FLASH AGAIN.
IF YOU HAVE 2 REMOTES, 1 NEW AND 1 OLD OR 2 NEW ONES,
PLEASE CONTINUE WITH STEPS 6 AND 7. IF NOT, SKIP TO END.
6. PRESS UNLOCK BUTTON ON DRIVER'S DOOR, THEN LOCK
BUTTON ON DRIVERS DOOR, LIGHTS WILL AGAIN FLASH
7. PRESS LOCK BUTTON ON 2ND NEW OR OLD REMOTE.
LIGHTS AGAIN WILL FLASH.
YOU ARE DONE. EXIT VEHICLE AND TRY YOUR REMOTE. IT WILL
NOT WORK FROM INSIDE CAR OR WITH KEY IN IGNITION.
Note: if your hazard lights flash after inserting your key in and
out, but you can't get the remote to program, you may have a
dead battery or the wrong remote. If instructions do not work,
do it again but when you get in - shut the door, buckle seat belt
and lock doors, then proceed to putting key in ignition
11/14/2017 iKeyless Confidential 6