User manual Hitec RED 6

11
Pairing
Place the transmitter and receiver within 2m of each other (but not less than
45cm) then power the transmitter ON.
Power the receiver ON noting that the LED will initially ash red / blue, then
change to fast ashing red. For initial pairing the receiver must be powered
on within 5 seconds of the transmitter. Once paired this time constraint is no
longer necessary.
Pairing will be complete when the receiver’s fast-ashing red LED turns solid
red. This usually works without issue, however if you are attempting to operate
multiple aircraft at the same time be sure that you only turn one transmitter
and aircraft on at a time, waiting for the two to pair before moving to the next. If
a mis-pair occurs simply turn off both units and begin the process again.
You can check the pairing operation by plugging a servo into a spare channel
and operating the respective control. Note: Always switch your KA-6 transmitter
ON before powering up your model and only switch the transmitter OFF after
powering down your model.
45cm (18”) to
200cm (78”) apart
LED