User manual Hitec RED 6

13
Trim Adjustment
The trim, or center position of each servo, can be adjusted using the four
digital trim levers. Ensure that the control surface is mechanically centered
before using the trim levers. Adjust pushrods to the correct length prior to
ying so that the trims are only used for ne adjustment in the air.
Try to keep all trims at their center position as large amounts of trim
compensation may mean that the servo’s full range of travel will be
restricted.
Elevon (Delta) mix
The KA-6 transmitter can be used to control a delta aircraft (or a ying
wing). This pre-programmed mix combines channels 1 and 2. In this way,
the ailerons can be operated as ailerons using the aileron joystick and as
elevators using the elevator joystick.
1. Activate the Delta function by moving the switch from Fixed Wing to
Delta.
2. Connect one aileron servo to channel 1 and the other to channel 2.
3. Check the operation of the ailerons. Moving the aileron joystick to the left
should result in the left aileron moving up and the right aileron moving
down.
4. Use the channel 1 reversing switch as necessary to reverse the servo
direction.
5. Now pull back on the elevator stick. Both ailerons should rise.
6. Use the channel 2 reversing switch to reverse the elevator servos’
direction if required.
Digital
Trim
Delta
Mixing