User manual Hitec RED 6

5
Vibration
The receiver contains precision electronic parts. Ensure that you avoid
vibration, shock, and temperature extremes. For protection, wrap the receiver
in foam rubber, or use some other vibration-absorbing material.
If you are ying near water, it’s also a good idea to protect the receiver by
placing it in a plastic bag and securing the open end of the bag with a rubber
band before wrapping it with foam.
Receiver antenna Installation
The KA-6 receiver has two aerials for maximum security. Please install as
shown:
F/S
B
6
5
4
3
2
1
2.4GHz
6-Channel Receiver
90°
WARNING: Never pinch or bend the antennas. Avoid locating the antennas
next to any components that are likely to create interference such as
batteries, motors, ESCs etc. Avoid locating the antennas in highly conductive
environments such as carbon ber fuselages etc.
Never change the length of the antennas. Cutting the length of either
antenna will seriously affect the receiver’s range.
Handling connectors
Always ensure that you maintain the correct polarity when connecting a servo
or battery connector to the receiver. When unplugging connectors from the
receiver, ensure you hold the plastic connector and do not pull directly on the
wires.