User's Manual

KCI Hoists Corp. reserves the rig
4.3 Starting-up
Proceed with caution; the equipment may not be connected correctly which may
lead to unforeseeable movements on starting-up.
Once the receiver has been connected, disconnect the power supply to the motors, (for
example, by removing the fuses) and power on the receiver. The receiver will enter into
the SCANNING mode while the own transmitter is off. The following receiver LEDs
should now light up:
SIGNAL: OFF if all radio channels in the band are free.
Flashing ON if the receiver is finding channels with RF signals. (Now
temporary ON fix).
POWER: ON, indicating that the power supply is correct.
HARDOK: ON, indicating the absence of defects on the board.
ID: OFF.
DATA: OFF if none of the radio channels contains signals belonging to a
RADF13 or RADS11 radio remote control system in the area.
Flashing ON if some do.
To enter into Standard Working mode follow the sequence:
1. Put a charged battery in the transmitter.
2. Turn on the key-switch.
3. Push down STOP pushbutton
4. Pull up STOP pushbutton. The transmitter LED should flash yellow-green during
a second.
5. Press Down Pushbutton to the second step.
ual ver0.4a.doc
ht to modify this information without prior notification.
Page 11 of 23
6. Press START
The transmitter LED should light up green indicating that
the transmitter is transmitting.
Figure 6 RAD-TF and RAD-TS pushbuttons
RADS11 and RADF13 Users Man