20 INCH METAL HIGH-VELOCITY OUTDOOR WALL FAN Model: ILG8E20-15 Owner’s Manual PLEASE READ AND SAVE THESE INSTRUCTIONS pg.
Intended Use: This product is intended for residential and office use etc., for industrial or other commercial applications. Use only with electrical wiring that is in good working order and that meets applicable codes and ordinances. If you have any questions whether your wiring is adequate, consult a qualified electrician. While using your fan, you should follow the IMPORTANT INSTRUCTIONS listed below.
Installation Instructions Use the following information as a guideline only. It is the user's responsibility to be sure the location and the wall surface can handle the weight of this fan (14.6 lbs.). 3. Align 3 screw holes on the middle of the metal plate and the holes on the fan bracket, then insert the screws and screw nuts to tight them up. (Fig. 6.7.8) The wall fan must be mounted on 12 inch (300mm) thick dry and cement ‑ grouted firm wall or on 4 by 5-inch wood studs / joists.
Maintenance: The Internal motor bearings are permanently lubricated at the factory and do not require any additional lubrication. Repair: DO NOT OPERATE THE FAN WITHOUT THE GRILLE IN PLACE. DO NOT USE THE FAN IF IT HAS MALFUNCTIONED OR BECOME DAMAGED IN ANY WAY. Storage: Keep original carton for storage of the fan. Coil and tie the power cord to avoid damage during storage.
How long is the warranty? This outdoor fan comes with a 1-YEAR LIMITED COMPONENT WARRANTY. If your unit does not appear to be working properly, please contact our service center by calling 1-800-317-1688. Prior to your call, we encourage you to visit our service related website www.ilivingusa.com for troubleshooting tips and service instructions if needed. Warranty Information Register your product at our website: Or visit iLivingUSA.
