Automatic Power Attic Gable Ventilator MODEL: ILG8G14-16T 120VAC, 60Hz 3.
TABLE OF CONTENTS Important Instructions………………………………………. 3 Specifications……………………..………………………….. 5 Installing Instructions……………………….…………..… 6-8 Operating Instructions……………………….………....… 9 Maintenance and Cleaning………………………………. 9 Troubleshooting…………………………………………….
IMPORTANT INSTRUCTIONS CAUTION: Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Do not use the fan if any part is damaged or missing. Protect yourself and others by observing all safety instructions. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference. WARNING: To reduce the risk of electric shock, do not expose the fan to water or rain.
other hidden utilities. 7. The wiring must be permanent. DO NOT USE EXTENSION CORD! Although the Powered Gable Ventilator may be wired directly to power, we advise that some type of shut off switch be installed on the line. Please see the section on electrical wiring for suggested wiring diagrams and instructions. 8. The fan should be mounted behind louvers or in a location where the entrance of drawn in water is unlikely. 9. For general ventilating use only.
WARNING: To reduce the risk of fire or electric shock, do not use this fan with any speed control device. SAVE THESE INSTRUCTIONS SPECIFICATION MODEL: ILG8G14-16T 120VAC, 60Hz 3.
INSTALLATION INSTRUCTION WARNING: Turn off the wall switch prior to servicing the unit. To avoid personal injury, wall switch must be turned off before servicing since the built-in thermal protection may turn on the circulator automatically. 1. A gable mount ventilator is intended to be mounted in a gable wall. If your existing gable vent is large enough, just mount the fan directly behind it.
4. Use a sabre saw to cut out the airway on the plywood for mounting the gable mount ventilator. 5. Place the fan mounting bracket on the plywood, center the fan over the opening and screw the bracket to the plywood. 6. Carry the Gable mount Ventilator and plywood assembly into the attic, position it behind the shutter and nail it to the gable framing. 7. Control box of metal housing gable mount ventilator was attached to the fan by a flexible conduit.
. Connect the Black and White wire line out from the control box to the electric lines controlled by a master On/Off switch as shown in the wiring diagram.
OPERATION INSTRUCTION Please set the Thermostat to a desired condition before operating. Use a screw driver to turn the arrow of the knob to the desire temperature mark on the panel of the control box. To avoid the possibility of overturning the fan, operate on a stable, level surface. Do not move fan while it is in operation. MAINTENANCE AND CLEANING WARNING: Parts replacement and troubleshooting to be performed only by qualified personnel.
TROUBLESHOOTING If your fan fails to operate, please follow these Instructions: 1. Make sure the fan is well connected and the electrical line-in is working properly. 2. Check for any obstruction. If you find an object, turn the fan “OFF”. Disconnect the fan and carefully remove the object. Reconnect the fan and turn it on again and see if it resumes normal. NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR FAN, PLEASE DO NOT ATTEMP TO OPEN OR REPAIR THE FAN YOURSELF.