Instructions / Assembly

BEFORE INSTALLATION
2
   
   
¡

¢ £
7
Installation
Instruction
1
Wires
Safety Cable
Downrod
Coupling Screw x 2
Bolt x 2
Clevis Pin x 2
Nut x 2
Washer x 2
Coupling
Motor Housing
Loosen Suspension Screw Sets
at top of Motor Assembly.
Route Safety Cable and Wires
through Downrod. Fix the
Downrod to the Coupling with
Bolt, Washer, Nut and tighten
them firmly then insert Clevis
Pin.
Clamp the Downrod with 2
Coupling Screw on Coupling to
prevent shaking during opera-
tion.
Lock Washer x 2
Motor Assembly x 1
12” Downrod x 1
Mounting
Bracket x 1
Canopy x 1
Canopy Cover x 1
Coupling Cover x 1
Blade x 6
AAA
Battery x 1
Remote
Control x 1
Hardware installed at downrod
1/4” x 5/8” Screw x 19
1/4” Rubber washer x 19
1/4” Flat washer x 19
1/4” Nut x 19
Hardware for blade installation
Wire Connector x 3
Hardware for bracket installation
1/4” Flat washer x 8
1/4” Lock washer x 8
1/4” Nut x 4
Clevis Pin x 4
1/4” x 1-27/32”
Hex Bolt
x4
Parts &
Accessories
Motor Assembly x 1
1/4 x50 mm
Wood Screw and Flat x 4
Hex Bolt, Washer, Lock Washer
Nut and Clevis Pin x 2
Pan Bolt, Flat Washer, Lock Washer,
Nut and Clevis Pin x 2
12” Downrod x 1
Mounting Bracket x 1
Canopy x 1
Canopy Cover x 1
Coupling Cover x 1
5
4 X 40 mm outlet
box screws x2
Washer M4 x 2
1/4” x 1-31/32”
Wood Screw
M4 Wood Screw x 2
M4 Washer x 2
x 4
1
2
3
4
5
6