Specification

16
REMOTE CONTROL OPERATION INSTRUCTIONS
(1) After the ceiling fan has been installed according to the assembly procedure and
connected according to power supply specifications, perform the remote control
and ceiling fan pairing procedure (refer to the remote control pairing method
below).
(2) After the pairing has been completed, you can use the remote control to turn
on/off the ceiling fan, and select speed.
OPERATING INSTRUCTIONS
Remote control pairing procedure:
1. Pairing instructions
(1) Apply power to the fan, within 30 seconds after applying power press the
(Power On/Off) button on the remote until response by a "Beep" Sound. Which
means pairing is successfully and remote will be able to control the fan.
Note: Pairing mode will not work after 30 seconds of applying supply power for . During the
pairing process, pressing any buttons will have no effect. Normal operation resumes after the
pairing process has been complete.
(2) When the remote cannot control the fan, please check the battery switch touching
normally or not, correction of the positive and negative, full or empty of the power.
(3) When the remote cannot control the fan, please check is there any existence of similar
remote controlled products nearby, then check whether they works, because remote
controlled product with the same frequency will disturb each other.
(4) Low voltage of battery will affect the sensitivity of the emitter and the signal reception
accordingly (the indicated light will flash out its warning when the battery get low
voltage), must replace if the battery is getting low voltage.
2. After successful pairing
The fan will operate normally and can be controlled with the remote control. For any
setting on the remote, the fan will response by a "Beep" Sound.
Remote controller can pair with multiple Fans as many as you wanted. But the Fans can
memorize the last two remote controller paired with them only.
3. Memory function
This fan has a speed memory function in case of power outages. If the fan operates at
maximum speed when it shuts off in a power outage, it will resume its operation at the
maximum speed when the power comes back on. The memory function registers the
last operating speed.
4. In case of blade replacement
Repeat steps from section 1 above (pairing procedure) after replacing the fan blades.