24” DRUM FAN MODEL: ILG8M24-70EC 115V 60Hz 0.
TABLE OF CONTENTS Important Instructions………………………………………. 3 Specifications and Wiring Diagram………………………. 5 Parts of the Fan ……………………….………………… 6 Installing Instructions……………………….…………..… 7-9 Operating Instructions……………………….………....… 10-11 Maintenance and Cleaning………………………………. 12 Troubleshooting…………………………………………….
IMPORTANT INSTRUCTIONS CAUTION: Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Do not use the fan if any part is damaged or missing. Automatic reset safety device in motor. To reduce risk of injury disconnect power supply before servicing. Protect yourself and others by observing all safety information.
7. Fan motor is equipped with an automatically resetting control circuit that will disconnect power if the motor overheats. Always unplug fan before removing guard, as motor may restart unexpectedly. 8. Do not operate any fan with a damaged cord or plug. Discard fan or return to an authorized service facility for examination and/or repair. 9. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances.
SPECIFICATION Model: ILG8M24-70EC 115V 60Hz 0.22HP 1. 3. 5. 7. Front grill screws and washers Propeller Side handle Controller, power switch and speed adjust 9. Back grill screws and washers 11. Washer 13. Base Rack 15. Wheels 2. 4. 6. 8. 10. 12. 14. 16.
INSTALLATION INSTRUCTION The drum fan has been fully assembled except the wheels. Wheel Assembly Instructions 1. 2. 3. 4. 5. Place the drum fan on a flat and level floor. Lift and support the base rack for assemble of the wheels. Remove the two screws and washers from each wheel axle assembly. Insert the axle assembly into the frame tubing. Align threaded holes of axle with holes in frame tubing and reinsert screws and washers. Tighten the screw. 6. Ensure wheels turn freely.
OPERATION INSTRUCTION Speed Control: 1. This fan employs the latest technology of EC (electronic commutator) and electronic control. 2. Switch on the fan. 3. Speed adjustment by the adjustment knob. Speed is continuously variable from 200 (min) to 1200 (max) rpm. 4. Turn the knob in clockwise direction will speed up the fan and vice versa will slow down the fan until stop. 5. Adjust the fan speed to your desired rate. Turn the knob slowly as the fan requires time to speed up or slow down.
MAINTENCE AND CLEANING WARNING: Parts replacement and troubleshooting to be performed only by qualified personnel. WARNING: Do not depend on any switch as the sole means of disconnecting power when installing or servicing the fan. Failure to do so may result in fatal electrical shock. WARNING: Unplug the fan from the wall outlet before servicing or cleaning. CAUTION: There are no user-serviceable parts except regular cleaning as described in this user manual.
TROUBLE SHOOTING If your fan fails to operate, please follow these Instructions: 1. Make sure the fan is plugged in and the electrical outlet is working properly. 2. Check for any obstruction. If you find an obstruction, turn the fan “OFF”. Unplug the fan and carefully remove the obstruction. Plug the fan in and turn it on again and see if it resumes normal. NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR FAN, PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE FAN YOURSELF.