Exhaust Fan Remote Control Kit OWNER’S MANUAL MODEL: ILG8SFRC
IMPORTANT INSTRUCTIONS READ & SAVE IMPORTANT INSTRUCTIONS 1. Disconnect power supply before connections are made to prevent possible electric shock and/or damage to equipment. 2. Read and follow instructions carefully. Failure to comply with instructions could result in fire, electric shock, injury to persons, and/or damage to equipment. 3.
This Remote Control Kit contains the following: • • • • • • • Control Box with Power Cord Power Cord (6 ft) for Hardwiring to the Fan Remote Control Remote Control Holder Screws Plastic Anchors Wire Connectors Installation 1. Turn power off at circuit breaker panel or fuse box. 2. Connect the power cord of control kit to a 120V/60Hz wall socket. 3. Then mount the control kit to the wall by two screws HORIZONTALLY.
. When any solid state speed controller is used, a humming noise will be present in the fan on low speed. This hum in no way affects the operation of the fan and is acceptable in most commercial/industrial installations. 6. How to match the remote control with the receiving box: During the pairing process, it is necessary to confirm that only one control box is powered on and operates a remote controller.
Operation Remote Control Descriptions A B E C F H G D Name and Function A. LCD display B. Power button C. Mode button D. Timer Button E. + Button F. - Button G. RH Button H. Temp Button Remote Control LCD Display Icons and indication 1. Fan mark for fan is running 5. Auto and Manual 2. Timer marks and setting 6. Fan speed setting bars 3. Attic and Room 7. Room Temperature 4. RH marks and setting 8.
Turn ON the fan: Power button Press Power button on the remote control to turn the Fan ON and OFF. The display will show the set temperature and Attic Temperature and mode. The default mode is Auto and temperature is 80 °F. If the remote only displays the SET temperature, which means the remote is on sleep mode (to extend battery life). To wake up the remote, press the Power button once. Set Mode Press MODE button to set the fan to Auto mode or Manual mode to High, Medium and Low speed.
RH is part of the Auto Mode, it will execute Auto mode after the RH stop flashing and turn the Fan ON and OFF when RH and temperature reach both settings. Press and hold RH button for 3 seconds turns the RH Off directly. RH display will dim. +/- button Anytime you press + or - button, it will adjust the set temperature and go directly into auto mode. When Set timer or RH mode, you can also use +/- button to adjust the set value. Temp Button This remote is capable of reading two location temperatures.