Thermospeed™ Controller OWNER’S MANUAL MODEL: ILG8SFST
IMPORTANT INSTRUCTIONS READ & SAVE IMPORTANT INSTRUCTIONS 1. Disconnect power supply before connections are made to prevent possible electric shock and/or damage to equipment. 2. Read and follow instructions carefully. Failure to comply with instructions could result in fire, electric shock, injury to persons, and/or damage to equipment. 3.
Installation 1. Turn power off at circuit breaker panel or fuse box. 2. Install the controller to a 120V / 60Hz wall socket. 3. Hardwire a power cord to the fan. Plug the power cord of fan into the socket of Thermospeed control to get power. Product Specification Model No.: ILG8SFST Voltage: 120VAC 60Hz Rated Current: 3.
Control Descriptions D A B C F Name and Function A. Set Temp Knob B. Fan Speed Knob C. Power Switch D. Power LED Display Operation Instruction Power control: Power Switch To start the controller, switch the power button to I position. To turn off the controller, switch the power button to position. Operating mode Fan speed control: 1. Adjust the fan speed according to the FAN SPEED knob , from large to small. 2.
Temperature control: 1. Adjust the setting temperature range from 32 degrees F to 130 degrees F using SET TEMP knob . 2. When the room temperature drops to ≤ the set temperature -2~3 degree F, the fan stops running. When the room temperature rises to ≥ the set temperature+ 2~3 degree F, the fan will turn on. 3. Turn the SET TEMP knob to the red line area “BYPASS THERMOSTAT”, to by pass temperature control; fan will run continuously regardless of temperature.
