Installation Guide

Please note: It is always recommended that a licensed electrician install electrical xtures. MAKE SURE THE ELECTRICITY IS OFF.
Secure black wires with the corresponding
black wires with the provided wire nuts.
1
2
3
4
5
6
Screw the provided 8-32 Crossbar Screws
into the innermost threaded holes.
* Shorter screws available for
no charge upon request *
Wrap ground wire around ground screw
on crossbar, then attach to ground wire
from electrical box with wire nut.
Use screws provided with electrical
box to attach crossbar to electrical
box. *NOT INCLUDED*
Rotate the xture as needed to get it level,
then use the acorn nuts to secure the xture.
Secure white wires with the corresponding
white wires with the provided wire nuts.
Our brass is raw and unlacquered. Brass is particularly susceptible to tarnishing with oils from our hands and chemicals like ammonia
in Windex. Use gloves while installing these xtures to prevent ngerprinting. If cleaning the brass is needed, we use Brasso. If you
choose, you may clear coat the brass to prevent any tarnishing with a clear spray lacquer. After extensive testing, our favorite is Krylon
ColorMaster CoverMax Clear Gloss.
Acorn Nuts (2)8-32 Crossbar Screws (2) Wire Nuts (3)Swivel Crossbar
For any inquiries or additional help, please contact [e-mail]
A SPECIAL NOTE ABOUT RAW BRASS
INSTALLATION INSTRUCTIONS
INCLUDED HARDWARE FOR SCONCES (CHANDELIERS, SEMI-FLUSH, AND PENDANTS ON THE REVERSE SIDE)
WALL SCONCE INSTALLATION GUIDE