Installation Guide

5.25"W x 2.5" H

14-4 AWG

WIRE GAUGE

POOL WATER BONDING KIT

PWBC-4-KIT

QTY

316 Stainless Steel

Pool Water Bonding Kit

• Placed directly in skimmer

• Rated for above

and below grade usage

• Includes:

316 Stainless steel bonding

plate, sealing washer, lock

washers, nuts, and ground lug

Swimming Pool

Water Bonding Kit

E523213

Kit de acero inoxidable 316 para

conexión a tierra en agua de piscinas

• Se coloca directamente en el skimmer

• Calificado para su uso por encima

y debajo del nivel del suelo

• Incluye: Placa de conexión a tierra

de acero inoxidable 316, arandela de sellado,

arandelas de seguridad, tuercas y terminal

de puesta a tierra

Kit de métallisation

pour piscine en acier inox 316

• Placé directement dans l’écumoire

• Adapté à un usage au-dessus

et au-dessous du sol

• Inclut : Plaque de métallisation en acier inox

316, rondelle d’étanchéité, rondelles frein,

écrous, et cosse de terre

PAGE 1
PWBC-4-KIT QTY 1 POOL WATER BONDING KIT WIRE GAUGE 14-4 AWG 316 Stainless Steel Pool Water Bonding Kit • Placed directly in skimmer • Rated for above and below grade usage • Includes: 316 Stainless steel bonding plate, sealing washer, lock washers, nuts, and ground lug 5.25"W x 2.
PAGE 2
INSTRUCTIONS 1. Drill a 3/16" hole in the side or rear of skimmer basket compartment depending on the desired location for attaching the bonding conductor. Hole placement should be at least 1-3/8" below the water line but at least 1-3/8" from the bottom of the inside of the skimmer. Note: When determining the position of the bonding plate take into consideration any obstructions there may be inside the skimmer. Some skimmers have molded features that will obstruct the use of this type water bonding plate.