Operation Manual
GETTING STARTED
iLuv | 3i399/398 | V11M11_IM_EN_012020092 | iLuv
i399/i398 supports both of external DC power supply and
battery power supply, before operate in battery power
supply, please unplug the external DC plug and install the
batteries as following instructions:
Installing the battery
GETTING STARTED
IMPORTANT:
1. Occasionally, les on iPod can become corrupted. This may cause an erratic behavior with your
iLuv products. Apple Inc. recommends that you visit their website www.apple.com to obtain
instructions on resetting or restoring your iPod to factory settings.
2. It is imperative that you use the correct dock adapter for your iPod and that the dock adapter ts
appropriately into the built-in universal dock. Ignoring these rules can cause severe damage to
your iPod. Please refer to the section “Installing the Dock Adapter” to properly install the dock
adapter before operating the i399/i398 with your iPod.
Installing the AC Adapter
Locate the AC adapter jack on the back of the unit.
Insert the AC adapter cable into the jack, and plug into the
wall outlet.
In order to oer consistent clock settings, the i399/i398 uses a backup battery system. This means
that in the event of a power failure, all time settings of the i399/i398 will remain saved. For example,
after the installation of the Backup Battery, the AC cord is disconnected or a power failure occurs,
the display will NOT remain lit, but the time and date settings will be temporarily maintained. To
install Backup Battery, follow the instructions below:
Installing the Backup Battery for Clock Settings
1. Locate the battery compartment on the rear side of the
unit and open the battery door.
2. Insert 8 pcs “D” size batteries, following the correct
polarity (+/-) drawings inside the battery compartment.
For longer battery life, alkaline batteries are suggested.
3. Secure the battery compartment by closing the door.
1. Make sure the connection between the AC adapter and the unit is secure. This is important
because during battery replacement it is possible for all settings to be lost if time have already
been set.
2. Locate the battery compartment on the rear side of the unit and open.
3. Insert 2 “AAA” batteries, following the correct
polarity (+/-) drawings inside the battery
compartment. For longer battery life, alkaline
batteries are suggested. Please note that new
and used batteries should not be mixed.
Likewise, alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries should
not be used together.
4. Secure the battery compartment by closing
the cover.
Important Notes on Batteries
To prevent battery leakage, which may result in bodily injury, property damage or damage to the
unit, follow these instructions.
· Install all batteries correctly according to the polarity (+/-) as marked on the unit.
· Do not mix old and new batteries, carbon and alkaline, etc.
· Remove batteries from the unit when the device will not be used for an extended period of time.
Please dispose the used batteries properly according to your local government regulations.