Operation Manual

OPERATIONAL INSTRUCTIONS
Digital Clock and Timer - continued
3. To set the minutes, press the
MEM./CLK ADJ. again and use
TUNING + SKIP/SEARCH or
TUNING – SKIP/SEARCH
to adjust. Conrm by pressing
MEM./CLK ADJ.
4. Press DISPLAY MODE to proceed to
setting the switch-o time.
5. Set the switch-o time using the
same procedure as switch-on
time setting.
6. Press DISPLAY MODE, as required
to check the current time,
Timer On, and Timer O.
7. Press TIMER (18)/(57) to activate
the timer.
When the unit is in standby, it will automatically switch on for the programmed length of time
in the last operating mode (CD, iPod or TUNER), in which mode this unit was before switched
o. Make sure the tuner is tuned to a radio station. For CD or iPod, a CD or iPod must be inserted
properly.
Snooze function
When the unit is switched on by means of the timer, you can press the SNOOZE button (40) to
switch the unit o for approximately 9 minutes. After this time, the unit switches on again. You can
press SNOOZE again, or switch the unit o by pressing POWER.
Setting the sleep timer
When the unit is in operation it can be set to automatically switch-o 10 to 90 minutes later. Press
SLEEP button (55), as required, until the desired delay time appears on the display. The SLEEP timer
can be set for: 90, 80, 70, 60, 50, 40, 30, 20, and 10 minute intervals. The unit automatically turns o
after the entered time has elapsed.
OPERATIONAL INSTRUCTIONS
Compact Disc Operation
Safety notes for operation of the CD changer
Press one of the OPEN / CLOSE buttons (15) or (16) to open the right or left CD cover (2) or (26).
The right and left CD cover do not open or close at the same time. Make sure the cover is not ob-
structed by any objects. This must also be ensured when closing the CD cover. The disc loader may
only be opened or closed by pressing either the button OPEN / CLOSE. Take care that no foreign
objects can fall into the unit when the disc compartment is open.
Under no circumstance should the laser pick up lens be touched. Never look directly
at the beam.
CD changer operation
Switch the unit on by pressing the
POWER button (1)/(34). To turn on
the CD mode, press the button
PLAY / PAUSE (13)/(41) or any one
of the DISC 1-4 buttons (5) or (52).
If one or more CD(s) have already
been inserted in the chosen
location(s), playback is started.
(TOC means Table of Contents)
If there is no CD inside, the following
will appear after a few seconds:
iLuv | 20i9300 | V10M10_IM_EN_1111200819 | iLuv
EU Only