Operation Manual
GETTING STARTED
For the rst time use, the battery is pre-installed for your
convenience. Pull out the insulation tag from the button battery
tray before operating the remote control as shown below.
First Time Use of Remote Control
1. Remove the battery tray by pressing point (1a) inside, then sliding area (1b) at the same time
2. Pull out the battery tray
3. Install or replace the button-type battery “CR2032” (supplied)
4. Close the battery tray
Battery Installation
WARNING Danger of explosion if battery is incorrectly replaced. Replace only with
or equivalent type.
1a
1b
2
3
4
OPERATIONAL INSTRUCTIONS
Switching the unit ON
Press the POWER button (1)/(34) to turn on the system (Conrm voltage setting before powering on.
i9300D only.).
Operating mode selection
The dierent operating modes can be directly selected using the buttons PLAY/PAUSE (13)/(41)
for CD operation and TUNER/BAND (23)/(56) for radio reception.
1. PLAY/PAUSE : Playback from the built-in compact disc player
2. TUNER/BAND : Radio, selection of the frequency bands
Adjusting the volume
To adjust the volume, press the
VOLUME UP/DOWN buttons
(4)/(43)/(45).
To turn the sound o, press
the MUTE button (25)/(58).
This function is indicated when
the word, MUTE appears
in the display (3).
By pressing the MUTE or VOLUME UP/DOWN buttons (4)/(43)/(45) again, the sound will turn
back on.
Amplier and Radio Operation
CAUTION! High volumes, especially with headphones, may damage your hearing.
Hearing experts advise not to hear music with high volume for a long
period of time.
iLuv | 14i9300 | V10M10_IM_EN_1111200813 | iLuv