U Manuaal User Charging Con nnect the USSB cable to the SmartSShaker 3 and d plug the other o end off the USB caable to any USB wall adapter. The LEED light sho ould blink white.After w c charging full (all LED offf or solid on n), you can detach the USB B cable. Set Up 1. Open th he Android App. ‐ Direectly click “G Get Started” and the click “Next”, “Next” till you will seee below scre eens. ‐ Justt wait for arround 10 seeconds. Then, you will see s the belo ow screen. JJust click Ne ext to go ah head.
. Then yo ou will see below b screeen. Click thee button at the t right bo ottom corneer. If there is i any prom mpt asking you y to accept location or Bluetootth access, ju ust click okaay. If the ap pp close, open it again and a you will see the beelow screen again. Clickk the button n at the righ ht bottom ccorner again n. 3. At this moment, m m make sure th he slide swittch is at on position. Prress and ho old snooze button b for 10s 1 on the device.
4. Click the button att the right bottom corn ner again. Th hen, you should see “SSmartShaker 3” as belo ow, click connect. Then n, the device should vib brate once. If you havee too many devices neaarby, you will w see multiple “SmartShaker 3”. In this casse, try to takke away tho ose SmartSh haker 3 devvice that you u will nott want to test. 5. Then, you will see below screeens. Click th he button in n the red do otted rectan ngle as belo ow.
6. Then, you will see below screens. Click the red dotted button as below. 7. Then, you will see below screen.
8. Just scroll down the screen. You will see below. 9. Click “Msg in”. Then, the device will vibrate once.
10. Click “In ncoming Call”, the device will vibrrate continu uously. You can click “C Call End” or the snoozee button on the deviice to stop the t vibratio on. Note: if the devvice is disco onnected du uring testingg,click “Msgg in” and “In ncoming Caall” will not have vibrattion effeect. please click c the “Co onnect” buttton at the top t right co orner to con nnect again.. Then, pleaase repeat step ps 5 ‐10. If yo ou close thee app and want w to test it next timee, just start from step 4 again.
FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
