User Manual


Gas connection (Fig. 3)
The connection to a gas tank or gas line must be made
by authorised personnel in accordance with AS 5601
after making sure that the cook top is prepared for the
type of gas available.
If not, see: “Adapting to different types of gas”.
Also check that the feed pressure falls within the values
shown in the table: “User characteristics”.
ISO 7/1
ISO 228/1 (FR)
Fig. 3
Metal rigid/semi-rigid connection
Make the hook-up with metal fittings and pipes (even
flexible hoses) so as not to stress the components inside
the cook top.
Note: - After installation, use soapy water to check the
perfect seal of the entire connection system.
Important note: make the connection using only metal
fittings and pipes (flexible, continuous-wall steel hoses
or rigid copper or steel tubing) and in such a way that its
entire length can be inspected.
Electrical connection (Fig. 4)
The installer must be qualified and is responsible for
correct electrical connections and following safety
standards.
Prior to carrying out the electrical connection, please
ensure that:
t sitahwwol lof otsahcuserasci tsi retcarahc tnalp eht
indicated on the data plate placed at the bottom of
the working area;
t that the plant is
with an earth connection,
following the standards and law provisions in force.
The earth connectionis compulsory in terms of the
law.
Should there be no cable and/or plug on the equipment,
use suitable absorption material for the working
temperature as well, as indicated on the data
plate. Under no circumstance must the cable reach a
temperature above 50°C of the ambient temperature.
If connecting directly to the mains power supply, fit a
multi-pole switch of a suitable size for the rated capacity
with a clearance distance which completely disconnects
the power line under overvoltage category III conditions,
consistently with the rules of installation (the yellow/
green earth wir must not be interrupted). The plug or
omnipolar switch must be easily reached on the installed
equipment.
Fig. 4
If the power cord is damaged, it must be replaced by the
manufacturer, its service department or a person with
similar qualifications, so as to prevent any risk.
For connection with a Flexible Hose
The hotplate can be connected with a Flexible Hose,
which complies with AS/NZS 1869 (Australian
Appro
ved), 10mm ID, class B or D, no more than 1.2m
long and in accordance with AS5601. Ensure that the
Hose does not contact the hot surfaces of the
hotplate, oven, dishwasher or other appliance that
may be installed underneath or next to the hotplate.
WARNING: Ensure that the hose assembly is
restrained from accidental contact with the flue or flue
outlet of an underbench oven. The hose should not be
subjected to abrasion, kinking or permanent
deformation and should be able to be inspected along
its entire length. Unions compatible with the hose
fittings must be used and connections tested for gas
leaks. The supply connection point shall be accessible
with the appliance installed.
17