GUIDA RAPIDA DI MANUTEZIONE E D’USO IT MAINTENANCE AND USER’S GUIDE EN MANUEL D’ENTRETIEN ET D’UTILISATION FR
CONTENTS EN SAFETY INFORMATION ...................................................... 12--12 INSTALLATION .................................................................... 13--13 OPERATION .......................................................................... 13--13 CONSERVATION .................................................................. 14--14 FREEZING ............................................................................ 15--25 DEFROSTING .............................................
Thank you for purchasing this product. Before using your refrigerator, please carefully read this instruction manual in order to maximize its performance. Store all documentation for subsequent use or for other owners.
Scrapping old appliance This appliance is mar ed according to the European directive 2012/19/EU on aste Electrical and Electronic Equipment ( EEE). EEE contains both polluting substances ( hich can cause negative consequences for the environment) and basic components ( hich can be re-used). It is important to have EEE sub ected to specific treatments, in order to remove and dispose properl all pollutants, and recover and rec cle all materials.
MAINTENANCE AN ENERGY SAVINGS For better energy savings, we suggest: • Installing the appliance a a from heat sources and not e posed to direct sunlight and in a ell ventilated room. • Avoid putting hot food into the refrigerator to avoid increasing the internal temperature and therefore causing continuous functioning of the compressor. • o not e cessivel stuff foods so as to ensure proper air circulation. • efrost the appliance in case there is ice (see EFROSTIN ) to facilitate the transfer of cold.
Freezer zone Defrosting the freezer compartment (static products Use the table belo for the compartments Freezing process can onl occur in the compartments ithout NO-FROST technolog ) When the layer of frost present in the freezer compartment exceeds 3mm, it is recommended to proceed with the defrosting as it increases energy consumption. 1) Rotate the knob to the „0“ position (Fig .3) 2-3 MONTHS 4-6 MONTHS ~ 6-8 MONTHS 10 - 12 MONTHS Fig.
REVERSING THE OPENING OF THE DOORS Remove the upper plate and hinge by screw driver. Remove the right bottom hinge and left plastic plugs, and refit them onto the opposite side. Remove the upper door. Use the opposite hinge and cover and fit into the left bottom. Reassemble the doors and hinges workings from bottom to top, from 1-2.
INSTALLATION OF THE APPLIANCE IN THE COLUMN Insert the appliance into the column, placing it on the opposite site of the hinges, and make sure 3-5 mm distance gap. After ensuring the match between appliance door and column door, then screw the appliance upper part to the cabinet 1 2 Screw the appliance lower part. Fit the seal to the appliance, cut off the excessive part if necessary. Fit the bottom parts with plastic covers.
COUPLING OF THE PANELS OF THE BUILT-IN COLUMN OF THE APPLIANCE DOORS The appliance is equipped with coupling devices for the appliance doors with the column panels (loader slide). Secure the slide in the inner part of the panel of the built-in column at the desired height and at approx. 20 mm. From the outer wire of the door.
TROUBLESHOOTIN PROBLEM The refrigerator and freezer do not suffi cientl cool. CAUSE • The doors are not closed. • The doors are frequentl opened • Erroneous setting of the temperature. • The refrigerator and freezer have been e cessivel filled. • Surrounding temperature is too lo . • No electrical po er. The motor runs continuousl . • The doors are not closed. • The doors are opened frequentl . • Ambient temperature is ver high. • Thic ness of frost than 3mm. The frozen food is tha ing.
/2015
