Use and Care for Majestic II

13
PERFORMANCE CHECKLIST
All burners are tested before leaving the factory. There are no adjustments for the burners if connected according
to the information on the rating plate. Check each burner for proper operations. Flames should be blue in all set-
tings. If service is required, contact your dealer for the name of their authorized service agency. Gas conversions
and initial installation are not responsibility of the manufacturer.:
The installer should carry out the following performance checks. Refer to instructions below.
1. Check surface burner ignition.
2. Check low  ame adjustment
3. Check for gas leaks (odors) at all gas connections.
REQUIREMENTS
Room ventilation – Location and venting.
ATTENTION: A exhaust fan may be used with the appliance; in each case it shall be installed in conformity with
the national standards in force.
ATTENTION: Exhaust hood operation may affect other vented appliances; in each case it shall be installed in
conformity with the national standards in force.
CONVERSION TO DIFFERENT TYPES OF GAS
Any conversion required must be performed by your dealer or a qualied licensed plumber or gas service com-
pany.
Please provide the service person with this manual before work is started on the range.(Gas conversions are the
responsibility of the dealer or end user.)
WARNING
This conversion kit shall be installed by a qualied service agency in accordance with the manufacturer’s in-
structions and all applicable codes and requirements of the authority having jurisdiction. If the information in
these instructions is not followed exactly, a re, explosion or production of carbon monoxide may result causing
property damage, personal injury or loss of life. The qualied service agency is responsible for the proper instal-
lation of this kit. The installation is not proper and complete until the operation of the converted appliance is
checked as specied in the manufacturer’s instructions supplied with the kit.
CAUTION
Before proceeding with the conversion, shut off the gas supply to the appliance prior to disconnecting the electr
ical power.
The appliance is supplied for use with a certain type of gas; if this has to be varied, you must change the bur-
ner
injectors, adjust the minimum gas ow.
Before carrying out these operations you must disconnect the electric power supply of the cooker to avoid
accidental contacts.
Before carrying out any maintenance work, disconnect the appliance from the gas and electric supply.