User's Manual

•
Insert one end of the audio cable (not included) into the LINE OUT jack on your
external audio unit and the other end into the Line In jack
9 on the rear of this
unit. To listen to the external audio unit, turn this unit on by pressing and
holding the Power button 4 until the indicator lights and turn on the external
u
nit as well. Repeatedly press the Source button
5 t
o select LINE IN mode; the
indicator will light purple. The external audio unit’s output sound will be heard
through this unit’s speakers. If you wish to listen to the bluetooth mobile device,
press the Source button
5 to select iPod mode; the indicator will light orange (or
b
lue if not paired).
OPTIONAL CONNECTIONS: LINE IN JACK (REAR OF UNIT)
GENERAL:
Power Source ........................................................................... DC 9V Adapter (Center Positive)
S
peaker. ................................................................................................................................. 2 x 4 ohm
Output Power ........................................................................................................................... 2 x 1W
Weight.............................................................................................................................................5.5 oz
Dimensions....................................................................................4 (W) x 2.4 (D) x 2.5 (H) inches
S
pecifications are subject to change without notice.
For additional setup or operating assistance, please visit www.memorex.com
F
or consumer replaceable part(s), verify part number(s) then contact our parts and
accessories fulfillment center at: 1-800-379-8439
L
OCATION OF CONTROLS
1 2 3 4 5
876
s
o
u
r
c
e
9. Line In Jack
10. DC In 5V Jack
(AC Adapter Part No. E18-00745-01*)
11. Battery Compartment
(Battery Compartment Cover Part No. P14-00262-01*)
1. Volume – Button
2. Volume + Button
3. Button
4. Power Button
5. Source Button
6. Microphone
7. Speaker
8. Indicator
9
10 11
SPECIFICATIONS
Imation Enterprises Corp.
1 Imation Way, Oakdale, MN 55128-3414 USA
www.memorex.com
© Imation Corp.
Memorex and the Memorex logo are trademarks of Imation Corp. and its affiliates.
code 1
code 2
TROUBLESHOOTING
SYMPTOM
No sound.
Bluetooth mode:
no sound.
CAUSE
Volume is set to minimum.
P
ower is not on.
Batteries are weak or
dead.
Unit is in Aux mode.
Unit is not paired.
SOLUTION
Increase volume.
P
ress and hold the Power
button to turn the unit on.
Replace batteries.
Press the Source button to
s
elect correct mode.
Pair unit (see the Pairing
a Bluetooth Mobile
Device section).
*For consumer replaceable part(s), verify part number(s)
then contact our parts and accessories fulfillment center at:
1-800-379-8439.