User Manual

Turning the Soma BT On or Off

1. Turn on the unit by sliding the Power switch

y, the orange will be visible in the switch

and the LED indicators will cycle and then

light to indicate the battery power (if one LED

is lit, then battery is low, up to all four LEDs lit

indicating full battery).

NOTE: If the unit has been paired previously and the

paired unit is close by, the right-most LED indicator

will light and a beep will sound to indicate it has

been paired.

2. Turn the unit off by sliding the power switch y,

the LED indicator will cycle and then turn off.

To Charge the Soma BT

1. With the unit on or off, plug the included cable

from the USB jack on your computer to the micro

USB jack v on this unit. While charging, the

battery level will be shown by the LED indicators

with the current level LED blinking. When all

the LED indicators light solid, then the unit

is fully charged.

2. If the power level is less than 10%, the left-most

LED indicator will start blinking, which means

that the Soma BT needs to be charged.

Using the Soma BT with a Bluetooth Device

1. Turn on the unit as shown above.

2. Press and hold the Bluetooth button U for

approximately three seconds until a beep

sounds and the right-most LED starts blinking.

3. Within five minutes, select Soma BT from the

Bluetooth List on the external device. See

external device’s owner’s manual for details.

When paired successfully, the Soma BT will beep

twice and the right-most LED will light solid.

NOTE: If the unit is not paired within five minutes,

the LED will stop blinking.

4. Audio played through the external device will

now be heard through the Soma BT.

Imation Confidential - Use Only By Permission

Controlled material extracted from Matrix on Feb 21, 2012

06:29:49 PM CST [Bundled with Packaging Configuration 99-

0000-2015-8 A]