User Manual

When charging NiCd or NiMH batteries, divide the capacity by current, then divide the result by

11.9, set this number of minutes as the value for safety timer setting. If the charger stopped at

this time threshold, about 140% of the capacity will have been fed into the battery.

For example:

Capacity Current Safety Time

2000mAh 2.0A (2000/2.0=1000)/11.9=84 minutes

3300mAh 3.0A (3300/3.0=1100)/11.9=92 minutes

1000mAh 1.2A (1000/1.2=833)/11.9=70 minutes

Safe timer Calculation

The program is only suitable for charging/discharging Lithium-polymer batteries with a nominal

voltage of 3.3/3.6/3.7V/cell. Different batteries have different charge technique. There are two

methods termed as constant voltage and constant current. The charge current varies according

to battery capacity and specification. The final voltage is very important; it should precisely

match the voltage of the battery: LiPo is 3.6V, LiLo is 4.1V and LiFe is 3.6V. The current and

voltage of the battery should be correctly set.

When you want to change the values of parameters, please press START/ENTER key to make it

blink and then use DES or INC to change the value. Then press START/ENTER key again to

store the value.

Lithium Lilo/LiPo/LiFe program