User Manual

Voltage balancing and monito ring in the dis charge process
Voltage balancing and monito ring in the dis charge process
The processor monitors voltage of each cell when the battery packs are during its “storage” and
“discharging” process. To achieve this feature, plug each battery to the charger individually. If
voltage of any cell is abnormal, B6 will show error message and terminate the program forcibly.
So if there is battery damage or disconnection, you can see the error message and press INC to
know which cell is damaged.
BATTERY VOL ERR
CELL LOW VOL
4.14 4.16 4.09
2.18 0.00 0.00
INC
The processor detects voltage of one cell is too low.
The 4th cell was damaged. The value of voltage may be zero if
disconnection occurs.
Charging of NiCd/NiMH battery
DEC
NiCd Sensitivity
D.Peak Default
NIMH CHARGE Aut
CUR LIMIT 5.0A
NIMH 2.0A 7.42V
CHG 022:45 00890
-
Batt type
Stop
Elapsed
time
INC
+
DEC
Start
Enter
-
‘>3 seconds’
INC
+
Charged
capacity
Battery
type
Charge
current
Battery
voltage
This program is for charging and discharging of NiCd/NiMH batteries
associated with R/C models applications. You can press START/ENTER
key to make it blink and then INC or DEC to change the parameter value.
Press START/ENTER key to store the value.
This program charge the battery using the current you set up. In the
“auto” state, you should set up the upper limit of the charge current to
avoid damage by excessive feeding current. Some batteries of low
resistance and capacity can lead to higher current in the “auto” charging
mode. But in the manual mode, it will charge with the current you set. You
can make it blink in the current field and press INC and DEC at the same
time to switch mode.
21