IE-MediaChassis/2 (AC) Operation Manual
FCC Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class A computing device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Table of Contents FCC Radio Frequency Interference Statement ........................................................ ii Warranty................................................................................................................ ii About the IE-MediaChassis/2 (AC) ..........................................................................1 Installing the IE-MediaChassis/2 (AC) ......................................................................2 Configuring and Installing Modules..............
About the IE-MediaChassis/2 (AC) The IE-MediaChassis/2 (AC) is a stand-alone chassis for use with iMcV modules. As an unmanaged chassis, the IE-MediaChassis/2 (AC) supports two single-wide or one dual-wide iMcV module. All iMcV modules, with the exception of the SNMP management card, will function properly in this chassis. The IE-MediaChassis/2 (AC) contains an internal AC power supply. The iMediaChassis/2 (AC) includes a temperature triggered fan.
Installing the IE-MediaChassis/2 (AC) Use the IE-MediaChassis/2 (AC) as a table-top chassis, mount in a Rackmount shelf, or mount it to a wall surface (brackets are not required). 1. Install the IE-MediaChassis/2 (AC) by placing it on a flat surface. 2. If mounting on a Rackmount shelf, align screw holes and secure with screws. 3. If mounting the chassis on a wall, place two #10 panhead screws (not supplied) on the wall the distance of the holes on the chassis, and then hang the unit on the screws. 4.
Configuring and Installing Modules IMC Networks recommends turning the chassis power off before proceeding. 1. To install an iMcV module, slide the module into the chassis until the module is firmly seated in the backplane. 2. Secure the module to the chassis by tightening the captive thumb screw on the iMcV module. 3. Attach the network cables between the iMcV module and other devices that will be interconnected. 4. Plug the chassis into the AC power source.
RackMount Precautions 1. Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack environment may be greater than room ambient. Therefore, consideration should be given to installing the equipment in an environment compatible with the maximum ambient temperature (Tma) specified by the manufacturer. 2.
IMC Networks Technical Support Tel: (949) 465-3000 or (800) 624-1070 (in the U.S. and Canada); +32-16-550880 (Europe) Fax: (949) 465-3020 E-Mail: techsupport@imcnetworks.com Web: www.imcnetworks.
Specifications Environmental Operating Temperature: -31° F to 176° F (-35° C to 80° C) Storage Temperature: -40° F to 185° F (-40° C to 85° C) Humidity: 5 to 95% (non-condensing) AC Input Specification Input Voltage: 90 to 264 VAC, 47-440HZ, 1A Inrush Current: <60A Peak @230VAC Input Power: <74W Output Current Capability: 11A@5 VDC Dimensions 2.23”H x 4.75”W x 7.30”D (5.7 cm H x 12.1 cm W x 18.6 cm D) Heat Generation 51 BTU/hr.
Electrostatic Discharge Precautions Electrostatic discharge (ESD) can cause damage to your add-in modules. Always observe the following precautions when installing or handling an add-in module or any board assembly. 1. Do not remove unit from its protective packaging until you’re ready to install it. 2. Wear an ESD wrist grounding strap before handling any module or component.
Safety Certifications UL/CUL: Listed to Safety of Information Technology Equipment, including Electrical Business Equipment. CE: The products described herein comply with the Council Directive on Electromagnetic Compatibility (2004/108/EC) and the Council Directive on Electrical Equipment Designed for use within Certain Voltage Limits (2006/95/EC). Certified to Safety of Information Technology Equipment, Including Electrical Business Equipment. For further details, contact IMC Networks.
19772 Pauling • Foothill Ranch, CA 92610-2611 USA TEL: (949) 465-3000 • FAX: (949) 465-3020 www.imcnetworks.com © 2008 IMC Networks. All rights reserved. The information in this document is subject to change without notice. IMC Networks assumes no responsibility for any errors that may appear in this document. IE-MediaChassis/2 is a trademark of IMC Networks. Other brands or product names may be trademarks and are the property of their respective companies.