Instruction manual

2
3.
If mounting the chassis on a wall, place two #10 panhead screws (not
supplied) on the wall the distance of the holes on the chassis, and then
hang the unit on the screws.
4.
Attach the cables between the chassis and the device that will be
interconnected, and then plug the unit into a reliable, filtered power
source.
Configuring and Installing Modules
IMC Networks recommends turning the chassis power off before proceeding.
1.
To install an iMcV module, slide the module into the chassis until the
module is firmly seated in the backplane.
2.
Secure the module to the chassis by tightening the captive thumb screw on
the iMcV module.
3.
Attach the network cables between the iMcV module and other devices that
will be interconnected.
4.
Connect the DC power source.