Owner Manual

INTRODUCTION
Installing the IMC Teddy Wall Cabinet is a straightforward procedure that can be accomplished with normal
construction materials and techniques. Installation procedures may vary due to eld conditions and state
regulations. Please note that the following instructions are recommendations only. The installer is responsible
for proper setting and making sure the appropriate codes are followed. Please contact the IMC Teddy Engineering
Department (800-221-5644) prior to considering retrot installations.
Please read the attached information carefully, as much of the information provided is reecting proven
installation techniques used in previous installations.
Parts Included
Tools/Materials Needed
Position wood blocks onto well-
studded wall at the appropriate height
above the oor and mark holes for
drilling. (Make sure all wood blocks
are level.) Screw wood blocks to
wall. (Hardware not included.)
Position cabinet against the wood
blocks. Drill screws through the
cabinet back panel & through the
wood block.
• OC Wall Cabinet
• (2) Stainless Steel Shelves
• (8) Shelf Support Clips
• Set of 2” Screws
• Drill with
3
⁄32” Bit
• Wood Blocks - # depending on cabinet
width
Shown w/ Optional
Solid, Hinged Doors
Step 1:
Step 2:
OC Wall Cabinet
Wood Block
Wall
Wall
Wall
Drill
Front View Side View
Wood Block
Rear of Cabinet
Side
of
Cabinet
S/S Shelves
Shelf Support Clips