User manual

ImmersionRC | EzOSD Manual
5
2. Installation without using the sensor board.
When the sensor board is not required, the OSD may be powered directly from an unused connector on
the R/C receiver. Cables to make this connection should be available from your local ImmersionRC
distributor.
If the cable is not available, those handy with a soldering-iron could take two standard servo cables,
remove the signal line (white/red/orange), connect the red wires together, black wires together, and on
the OSD end of the cable, swap the red/black pins so that the red wire is on the +5v pin of the EzBUS, and
the black wire is on the Gnd pin of the EzBUS.
Video Standard
When provided with a standard composite video input, in either the PAL, or the NTSC format, the EzOSD
will automatically switch to match the input format.
When powered up (usually for the first time), without a video input signal connected, the EzOSD will
default to PAL mode.
To change this, power up the OSD with either the UP, or DOWN buttons pressed. The DOWN button will
switch to PAL mode, the UP button will switch to NTSC.
Switch Functions
The EzOSD is configured using three simple push-buttons. No need for a complex switch setup in your
R/C transmitter, and no need for any external hardware.
Preferences Menu
The center switch, marked MENU, will enter the simple preferences menu, shown below. All settings
are accessible via a single menu.