Operation Manual


The Anatomy of a Vortex 150/180 Mini
Connectors and Switches
1) USB connector, used to configure the flight controller and upgrade the Vortex firmware.
Note that when used with most USB hosts, a separate battery connection is not required when
connecting to the USB connector.
Please
be
careful
not
to
put
too
much
strain
on
this
connector.
It
is
a
lightweight
surface-mount
part,
and
if
the
quad
is
dragged
around
by
the
USB
cord
it
may
not
survive.
2) Reset button, used to change Video Tx band, to restart the wizard and also to put a spektrum receiver
in bind mode.
Press and release after 1st beep to change video band, release after 2nd beep to restart the wizard,
release after 3rd beep to put a (non-autobind) spektrum rx in bind mode, finally release after 4th beep
to cancel operation.
Note:
To
bind
a
Spektrum
Rx
using
the
reset
button,
the
vortex
must
be
placed
in
SPEKTRUM
1024/2048
mode,
and
not
AUTO
mode,
using
the
Vortex
Configurator
on
a
PC
or
Mac.
6