User Manual

ManualsBrandsImoli ManualsAutomotive2000W Power Inverter, DC to AC 12V to 110V/120V, 4000W (Peak) Car Converter Automotive Modified Sine Wave Type with 2 Outlets and 2 USB Charging Ports

Dear customer, you can find solutions in the following failure analysis if you

encounter problems during using.

Fault/Display:Incorrect output voltage

Cause:

1. The battery power of RMS Multimeter is low.

2.Multimeter is subject to slight deviations in testing the output power of inverter.

The low eletric power and small capacity of the battery are one of the reasons which

cause the current in low situation when the inverter is operating.

Solution:

1. Use a true RMS multimeter to measure, such as the model FLUKE 177/179.

2.Try to maintain the input voltage in the range of rated power.

3.Change the battery of the multimeter then test again.

Fault/Display:No output voltage

Cause:

1. The switch of the inverter is off.

2. There is an error in connection of positive pole and negative pole between inverter

and car battery

3.car battery is near ran out of power, inverter will not work.

4.Our inverter is a modified sine wave type, it cant power Resistive load device. So

when the inverter was connected to the Inductive load device, it will stopped

working due to overload situation.

Solution:

1.Tum on the power switch.

2. Check the cables and make sure they are tightly connected.

3.Fully charge the car battery.

Fault/Display:Cannot drive the load

Summary of content (4 pages)

PAGE 1
Dear customer, you can find solutions in the following failure analysis if you encounter problems during using. Fault/Display:Incorrect output voltage Cause: 1. The battery power of RMS Multimeter is low. 2.Multimeter is subject to slight deviations in testing the output power of inverter. The low eletric power and small capacity of the battery are one of the reasons which cause the current in low situation when the inverter is operating. Solution: 1.
PAGE 2
Cause: 1. Load power is too large, or the actual power of the appliance exceeds nominal power. 2.Turn on the inverter switch before car starts , it will lead to damage. Because when the car starts, the instantaneous power is too large. 3.The inverter was incorrectly connected with the car cigarette lighter to power the devices which is over 150W-200W. 4.Our inverter is a modified sine wave type, it cant power Resistive load device (such as motor).
PAGE 3
) The nuts of the connection posts must be tightened to ensure well connected. 4) Press the power switch for one second, because it is a long press type switch. WARNING: REVERSE CONNECTED THE CABLES WILL DAMAGE THE INVERTER AND AVOID YOUR WARRANTY! 5) Before plugging anything into your inverter, make sure the appliance you are trying to power is shut OFF, then plug it into the AC outlet of your inverter and power on your appliance.
PAGE 4
can be connected. Check the rate power before use: We suggest buyer please check the rated power of the electric appliances device and inverter before using to avoid the overload situation. Make sure that the total rated power of the connected devices is less than the continuous working power of the inverter. If the power of devices beyond the continuous working power of the inverter , the inverter over-load protection feature will start to cut off the power supply for safety.