Instructions

The system indicator stays on with white light for 10 s, and then off, which
means the base station is connected to the network.
About the Guide
This quick start guide is for reference only. Minor difference might be
found in user interface.
All the design and software here are subject to change without prior
written notice.
All trademarks and registered trademarks mentioned are the
properties of their respective owners.
Please visit our website or contact your local service engineer for
more information.
If there is any uncertainty or controversy, please refer to our final
explanation.
-
-
-
Safety Instructions
- Do not short circuit the battery with other metal.
- Do not heat the battery or throw it into fire.
- Do not take apart the battery or press it to make it deformed.
- Keep the battery away from children.
- It is recommended to use the original battery.
- Do not use the battery at temperature above 60℃/140℉.
- The battery cannot be charged at temperature below 0℃/32℉.
- Recycle the waste battery as local regulations instructed.
Base stationAdding
Installing
Camera
Make sure the mounting surface is strong enough to hold at least
three times the device weight.
Step1
Drill screw holes on the mounting surface as the positioning
map shows, and then put in the expansion bolts.
Step2
Open the bracket, and then attach the bottom of the
bracket to the mounting surface with the self-tapping screws.
Step3
Attach the other half of the bracket to the camera, then
adjust the lens to the ideal angle, and then fix the bracket.
Self-tapping Screw
Mounting Surface
Bracket
Bracket
Step 1
Note:
Keep the distance of the base station and the camera within 30 cm (12 inches) during pairing.
You can pair six cameras at most with one base station, and pair one camera at a time.
Step 1
Step 2
CameraPairing
Step 3
Power up the base station, and then connect the Ethernet port to your
router with the network cable.
Scan the following QR code or serach “Imou” in Google Play or App
Store to download and install the Imou App.
Note:
Expansion Bolt
Step 5
Step 4
Do the following operations to finish adding base station.
Run Imou App, and then register an account for first use.
Add Device
Device
Scan
Admin password
Setup
OK
Step 2
Step 3
The pairing starts, and the indicators flash as described below:
The system indicator on the base station stays on with white light for
10 s, and then off.
The indicator on the camera stays on with green light for 10 s, and
then off.
The pairing succeeded then.
On the base station: Press the SYNC button, and then the system
indicator on the base station flashes with white light.
On the camera: Press the SYNC button, and then the indicator on the
camera flashes with green light.