Instructions / Assembly

HOW TO INSTALL BIFOLD DOORS - INSTRUCTION MANUAL.
*Plastic Door Aligners(O) - only used when installing 2 pairs of bi-fold doors in the same opening
STEP 3
Place Oak saddle (D) on floor,
1/4” back from closet opening
front edge to align with metal
track above.Holes in oak saddle
go on same side as plastic pivot
block.Door opening to left- holes
go on left.Don’t screw the saddle
to the floor until the end of in-
stallation.
1/4”
Oak Saddle
(A) WOOD BLOCK
(B) METAL TRACK (WITH
PIVOT BLOCK INSERTED)
(C) OAK SADDLE
(D) METAL FLOOR PLATE
(E) ROLLER BRACKET
(F) SPRING
(G) TOP PIVOT PIN
(H) TOP PIVOT BRACKET
(I) ADJUSTING BOLT
(J) BOTTOM PIVOT BRACKET
(K) HANDLE
(L) 2 - 2.5” WOOD SCREWS
(M) 22 - 5/8” #8 SCREWS
(N) 2 - 1/2” #10 HEX HEAD
SCREWS
(O) PLASTIC DOOR ALIGNERS
(P) DOOR TO WALL ALIGNER
Following hardware included :
A
B
C
J+I
K
O
E
H
D
B
F
G
STEP 4
Lay metal floor plate(E) over 4
holes drilled in oak saddle
(D)(slotted holes in plate go in
closet door).Fasten plate to
saddle using 2-hex head
screws (N) through slots in
metal floor plate.
Oak Saddle
(N)
STEP 5
(F)
Next open your door
& lay it face down.-
Drop spring into hole
present on top of the
door; door opening to
left use hole in top left
& vice versa.
STEP 2
With the flat side of the track
facing the room push the
metal track over the wooden
block for snug fit.Make sure
that pivot block is facing the
side you want the door to
open towards.Fasten track to
the wood using two #8 screws
through the two holes on the
inside of the track .
#8 screws
STEP 6
Slide rounded end of Top Pivot
pin (G) up through Top Pivot
Bracket (H)
(G)
(H)
STEP 1
Attach wood block (A) to top
of closet opening using
two-2.5” black wood screws.
Block should sit 1/4” back
from the edge of the closet
door frame.
A
2.5” WOOD SCREWS
(x2)
P
TOOLS REQUIRED
Drill
1/8” drill brit
Phillips screwdriver
Tape measure
3/8” Wrench