User Manual
11
Precautions ⚠⚡
Before using the Cruiser TTL, please
read the following safety notices
carefully and thoroughly. This will
ensure safe use and help prevent
damage to your ash and injury to
yourself or others.
Prolonged, fast shooting at
fast recycling rates might cause
overheating. The Cruiser TTL’s
protection circuit will shut the unit off
for approximately 5 to 10 minutes if
overheating occurs.
Warning
• There are no user-serviceable
parts inside the unit. Only
qualied service engineers
should access the inside of the
case. Due to the high-voltage
circuitry inside this device, do
not attempt to disassemble or
repair the unit yourself. Doing so
will void the warranty.
• Do not re the ash at close
range directly into the eyes of
people or animals. This can
cause damage to the retina and
may even lead to blindness.
• If the ashtube or modeling light
becomes cracked or damaged in
any way, replace immediately.
• Frequent use of HSS will have
an adverse effect on the lifetime
of the ashtube.
• Do not use or store the Cruiser
TTL 500 in ammable conditions
(such as environments
containing ammable gases or
liquid chemicals). This could
damage the ash, start a re, or
cause an electric shock.
• Do not clean the Cruiser TTL 500
with agents containing corrosive
or ammable substances such
as paint thinner, benzene, or
nail-polish remover.
• This product is not water
resistant. Keep it away from
rain, snow, humidity, and general
moisture.