User Manual

20
The Cruiser’s ash power output level can be set manually in 1/10-stop
increments over a 9-stop range. 10 is the full-power ash, and each stop halves
the light output.
To use the Cruiser in manual mode, follow these steps:
1. Connect the sync cord to the Cruiser and to your camera. Follow your
camera’s instructions for using the correct camera settings for manual
exposure photography.
Note: If the TTL icon appears onscreen while using the Cruiser Wireless
Controller, press the Mode button on the wireless controller to exit TTL
mode.
1. Set the ash power output, and adjust the modeling light power.
2. Set the exposure setting you want to use on your camera (check your
camera’s manual for specic instructions).
3. Take a test exposure, and make the necessary changes to the camera or
monolight.
Tip: For best results, use a handheld ash meter when shooting in the
manual ash mode.
Using the Cruiser in Manual Mode