User Manual

Mounting the Astral Extreme

1� Make sure the mounting bracket’s

ratchet handle is fully tightened�

2� Loosen the locking knob on the mounting

socket and mount the Astral Extreme

onto your lightstand�

3� Tighten the locking knob until secure�

You can adjust the tilt of the monolight by loosening the ratchet handle� Make sure to

keep one hand on the monolight to hold it steady to avoid damaging the light�

Setting Up

After mounting the Astral Extreme on your lightstand, you will need to install the

modeling lamp and the reﬂector�

IMPORTANT! Do not touch the modeling lamp or ﬂashtube with your bare hands� Oil

residue from your ﬁngers can cause the surface of the ﬂashtube to heat unevenly and

explode� Always wear cotton gloves or use a clean cloth when handling the modeling

lamp or ﬂashtube�

Getting Started