User Manual

5
Assembly Instructions
3. Insert the plain end of rst ex
rod in any of the eight ex rod
sockets on the xture head.
Adjust the softbox so that the
ex rod is aligned with one of
the pockets on the outer edge
of the softbox. Insert the stud
end of the ex rod into the
pocket by bending it so that it
can be inserted into the pocket.
4. Attach the next rod directly
opposite to where the rst rod
was inserted. Insert the plain
end into the ex rod socket
rst, and then insert the stud
(silver) end into the pocket on
the softbox.
5. Attach the next two rods at a
90° angle from the rst two
rods that were inserted. Follow
the same steps as with the rst
two ex rods: insert the plain
end into the ex rod socket,
and rmly bend the ex rod so
that it can be inserted into the
pocket on the softbox.