User Manual

Operating Instructions

Adjusting the angle

Rotate the ratchet-and-tilt locking handle

counterclockwise until loose. When there is no more

room to swing the ratchet handle, pull the handle out

until it’s able to freely rotate back to another position, and

continue to loosen. Tilt the ring light xture to the desired

position. Rotate the handle clockwise to tighten.

Attaching the camera bracket

Gently place the Ring Light

facedown on an even surface.

Unscrew and remove the

camera bracket locking knobs,

and place two of the included

rubber washers over the

threaded sockets. Align the

camera bracket cutout with the

sockets, and keep the padded

arm facing upwards and behind

the lens opening. Place the remaining two rubber sockets

onto the bracket, and then insert and tighten the bracket

locking knobs until secure.