LSP-SCS/B Studio Column Stand with Sliding Arm INSTRUCTIONS
Introduction Thank you for choosing Impact. The Impact LSP-SCS/B Studio Column Stand with Sliding Arm offers an effective solution for swiftly and effortlessly moving and adjusting one or more light fixtures around the set. The spring-loaded sliding arm is easily operated, and it provides sturdy support for fixtures weighing up to 17.6 pounds. The sliding arm can be positioned anywhere along the column at the maximum height of 7.
Precautions ⚠ • Please read and follow these instructions, and keep this manual in a safe place. • Use only parts provided by the manufacturer. • Make sure everything is secure before proceeding. • Always use a steel safety cable (not included) when suspending a light fixture or other assembly. • Make sure that this product is intact and that there are no missing parts. • Do not exceed the maximum load capacity. • Keep this product away from children.
Overview 1. Extension column 1 2. Bridge 3. Reversible stud 2 4. Locking knob 5. Sliding arm 3 4 5 6. Cable clip 7. Hex key 6 7 8. Main column and legs 9.
Setup Attaching the Wheels and Setting the Legs 1. Make sure the wheel locks are in the locked position by pressing down on the tab marked “On.” 2. Once the wheels are locked, screw them into the legs. 3. Pull the spring-loaded leg locks to free the legs, and unfold the legs until they lock into place. 3 For uneven surfaces, adjust the leveling leg screw by inserting a hex key or a screwdriver into the hole and turning to adjust the leg height until the base is stable.
2. Press the two sides of the bridge together and insert it into the main column. Make sure the set screw is aligned with the hole in the main column. Use the hex key to tighten the set screw until secure. 2 3. Align the hole in the column extension with the set screw on the bridge. Insert the extension over the bridge, and tighten the set screw with the hex key. 3 4. Loosen the locking knob on the sliding arm, and insert the pin. Tighten the lock until secure.
Specifications Load Capacity 17.6 lb. (8 kg) Mounting Options 5/8 in. stud 1/4-20 male thread Number of Sections 2 Column Diameter 35 mm Maximum Working Height 7.25 ft. (2.2 m) Max Height w/o Extension 45 in. (114.3 cm) Collapsed Height 40.5 in. (102.7 cm) Footprint Diameter 42 in. (106.7 cm) Pistol Grip Length 10.5 in. (26.7 cm) Column Extension Length 42 in. (106.
One-Year Limited Warranty This Impact product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of one (1) year from the original purchase date or thirty (30) days after replacement, whichever occurs later.