User's Manual

6
2. Press the two sides of the bridge together and
insert it into the main column. Make sure the set
screw is aligned with the hole in the main column.
Use the hex key to tighten the set screw until
secure.
4. Loosen the locking knob on the sliding arm, and
insert the pin. Tighten the lock until secure.
Note: The pin has a milled at surface to prevent it
from twisting in the mount. Make sure the at side
of the pin faces the lock.
3. Align the hole in the column extension with the set
screw on the bridge. Insert the extension over the
bridge, and tighten the set screw with the hex key.
To mount a ballhead or other xture on the arm, reverse
the pin by inserting the 5/8-inch end into the receiver so
the 1/4-20 screw is exposed.
2
3
4