User's Manual

Using Your Transceiver as a Shutter Release

Option2:Two-ClickContinuousShooting

1.With all devices turned off, connect and secure the transceiver to the camera by plugging

the camera dedicated shutter release cable into the Camera remote [

] port and the

other 3.5mm end into the transceiver’s output [

]. (Attach the Transceiver to the

camera by using the lanyard or a cold shoe bracket)

2.Turn on your camera and set it to continuous shooting mode. Make sure to set your

shutter speed to any other than Bulb.

3.Turn on the transceiver and set it to Transmitter/Receiver (Tx/Rx) mode using the M

button. Next, activate the transceiver’s Bulb mode by holding down the Bulb Mode

button. The LCD display will ﬂash a B to indicate when the function has been activated.

4.On the transceiver, half press the Shutter Release button to auto-focus the camera.

5.Fully press the Shutter Release button to activate the camera’s shutter. A timer will

appear on the LCD panel displaying the time elapsed.

6.Press the button again to stop continuous shooting.

7.Push Bulb button twice to turn off “B” mode.