User Manual

Wireless Remote Triggering with Studio Strobe

1.With all of the devices turned off, connect and secure the receiving (on-strobe)

transceiver to the studio strobe. Among other ways, this can be done using the included

lanyard strap or supplied adhesive-backed hot-shoe mount. The backing of the mount

can be trimmed as necessary.

2.Connect the studio strobe to the on-strobe transceiver using the appropriate cable to the

3.5 mm output sync [

] port.

3.Turn on the camera, studio ﬂash, and transceiver units.

4.Set the on-camera transceiver to Transmitter (Tx) or Transmitter/Receiver (Tx/Rx) mode

using the M button.

5.Set the on-strobe transceiver to Receiver (Rx) or Transmitter/Receiver (Tx/Rx) mode

using the M button.

6.Select and match the channel and group settings on the transceivers.

7.Trigger the studio strobe by pushing the on-camera shutter release button or the on-

camera transceiver’s Test button

If your studio light has a 1/4” phono jack, you will need to use the included 3.5mm to 1/4”

phono adapter. Additional sync cables are available separately.