User Manual
8
Synchronizing Channels
For the PowerSync system to work properly, the transmitter and
receiver must be set to the same channel.
The lanyard features a pin tool for changing the DIP switches.
To set the channel, follow these steps:
1. Make sure both units are turned off.
2. Use the diagram below to set the
DIP switches on the transmitter and
receiver to the same conguration.
3. Turn on the transmitter and receiver.
4. To test the setup, press the test button
on the transmitter. The receiver’s LED
indicator will ash to indicate correct
synchronization.
The PowerSync Mini is backward compatible with the PowerSync 16 and
PowerSync 16-80 systems (see Backward Compatibility below.)
Channel 1 Channel 2 Channel 3 Channel 4 Channel 5 Channel 6 Channel 7 Channel 8
Channel 9 Channel 10 Channel 11 Channel 12 Channel 13 Channel 14 Channel 15 Channel 16
Channel