User Manual

The modeling light has two modeling light modes:

Proportional: When the model light is activated, the

default setting is proportional, as indicated by the

and icons on the LCD panel. As you

adjust the monolight’s power output (using the output

adjustment dial), the modeling light will adjust up or

down proportionally. This gives you the general idea

where highlights and shadows will fall in relation to

the ash power.

Independent: To change from the default setting,

press the output adjustment dial a second time. The

icon will disappear from the LCD screen.

Independently control the modeling lamp’s light output

by pressing the or modeling light output buttons.

NOTE: Each button press changes the power output

of the modeling light by one tenth unit. To increase or decrease the numbers

displayed on the screen faster, press the adjustment button. Holding down the

up or down button will then increase the changing speed.

Press the output adjustment dial a third time to power off the modeling light.