User Manual

16
The Impact Digital Monolight has seven optical slave/pre-ash modes. You can
toggle between them by repeatedly pushing the slave button until the required
number is indicated by the light on the right side of the panel.
Activate this mode by pressing the slave button once. The
1
icon will appear on
the LCD. Press it again to turn it off. The icon will appear on the LCD.
To adjust the slave/pre-ash settings, press and hold the Slave button for four
seconds. Use the modeling light output buttons to toggle between modes.
C0: Using your master ash, release a test exposure. The monolight will
automatically memorize the amount of preashes red.
C1: The monolight will ash when it detects another ash.
C2: The monolight will trigger after one preash.
C3: The monolight will trigger after two preashes.
C4: The monolight will trigger after three preashes.
C5: The monolight will trigger after four preashes.
C6: The monolight will trigger after ve preashes.
Slave and Pre-Flash Settings
MODEL
FLASH
READY
110V AC
FLASH
2