User Manual

Setting (t) 1 2 3 4 5

Time (sec) 1 2 3 4 5

NOTE: The default setting of this function is t2, which means the ash will only

be triggered after 2 seconds of pre-ashes. When using multiple speedlites with

different pre-ash frequencies, this mode will group all the ashes as one before

ring.

Block Time

The Block Time function allows for a variable of 1 to 18 milliseconds for the

studio ash to ignore master pre-ashes. In this mode, your monolight will begin

to record and learn to recognize your device’s pre-ashes. This is to compensate

for the different pre-ash timing between devices. To use this function, refer to

the following instructions:

Press and hold the slave button for 8 seconds.

Press the slave button again.

Use the or modeling light output buttons to select your required setting.

Value (b) 1 2 3 4 5 6 7 8 9

Time (ms) 2 4 6 8 10 12 14 16 18

NOTE: The default setting on this mode is b5.