User Manual

The Flash Tube

The Impact Digital Monolight’s ash tube is user-replaceable. To replace the

ash tube, do the following:

1. Discharge the ash unit by pressing the test button.

2. Power off the monolight and unplug the power cable from the ash unit

and power source.

3. After 30 minutes, remove the modeling lamp and any other accessory

connected to the unit.

4. Wearing a pair of cotton gloves or using a soft,

dry cloth and holding a pair of needle-nose pliers,

carefully unhook the retention spring loop of the

ash tube. Make sure it is disengaged from the

ash tube.

5. Once it is unhooked, grip the base of the ash

tube on each side and carefully pull it from the

monolight.

6. Pick up the new ashtube and push its pins into the sockets using rm,

even pressure at the base.

7. With needle-nose pliers, hook the retention spring over and above the

ash tube.

8. Reinsert the modeling lamp, then attach any accessory to the monolight.