User Manual
21
Note: The default setting of this function is t2, which means the ash will be triggered
after 2 seconds of preashes. When using multiple speedlites with different preash
frequencies, this mode will group all the ashes as one before ring.
To exit the Time Frame function menu, press and hold the slave button for
approximately 4 seconds until the ash power setting appears on the screen, or
slightly move the adjustment dial.
Block Time
The Block Time function allows for a variable of 1 to 18 milliseconds for the
studio ash to ignore master preashes. In this mode, your monolight will begin
to record and learn to recognize your device’s preashes. This is to compensate
for the different preash timing between devices. To use this function, refer to
the following instructions:
1. Press and hold the slave button for 8 seconds.
2. Press the slave button again.
3. Use the
or modeling light output buttons to select your required setting.
Use the following chart as a reference for this function’s settings:
Value (b) 1 2 3 4 5 6 7 8 9
Time (ms) 2 4 6 8 10 12 14 16 18
Note: The default setting on this mode is b5.
To exit the Block Time function menu, press and hold the slave button for
approximately 4 seconds until the ash power setting appears on the screen, or
slightly move the adjustment dial.