Use and Care Manual

7
ENGLISHESPAÑOLFRANÇAIS
OPERATING INSTRUCTIONS (CONTINUED):
MODES OF OPERATION
There are three modes of operation: Comfort*, Standard and Continuous modes.
1. COMFORT MODE
Comfort mode is a setting whereby an ideal humidity setting (between 45-55% relative humidity) is auto-
matically chosen based on fluctuating environmental temperature. This is a great choice for a living space.
2. STANDARD MODE
In Standard mode, you can choose your desired humidity level from 35% to 85%. What level you choose
can depend on a number of factors including personal comfort, surrounding temperature and outside tem-
perature. Use the  and  buttons to select the desired level. Aer about four seconds, the display resume
showing the current humidity level. If at any time during operation you press the  or  key once, the display
will show the set level. It can be re-adjusted at any time.
NOTE: When operating in Comfort or Standard modes, the compressor and fan will cycle on and o as
needed to maintain the optimum or desired humidity level. At some point the unit may be completely
silent.
3. CONTINUOUS MODE
In continuous mode, the unit’s compressor will run continuously until the unit is powered o or another
mode is selected. This will remove all the moisture from the air that it’s capable of. This mode should be
used for the first three or four days aer setting up your dehumidifier to get room and unit ready for proper
operation in Comfort mode or Standard mode at a set humidity level.
CONTROL PANEL OVERVIEW:
The following diagram and legend shows the functions of the front operating panel. Some functions are
only available on select models.
When you push the button to change operation modes, the unit will make a beep sound to indicate that it
is changing modes.
*Comfort mode not available on all models
Fig. 4
TIMER
On
Off
Defrost
Full
CONT.
POWER
ION PUMP COMFORT FILTER TURBO
LED lit:
Continuous
mode on
Button:
Toggle mode
LED lit:
Comfort
mode on
Button:
Toggle mode
LED lit:
Filter needs
replacement
Button:
Reset
filter indicator
LED lit:
Pump mode
on
Button:
Toggle mode
LED lit:
Turbo mode
(high fan) on
Button:
Toggle mode
LED lit:
Ion mode
on
Button:
Toggle mode
On LED lit:
Unit set to go on
Off LED lit:
Unit set to go off
Button:
Program timer
LED lit:
machine is in
auto-defrost
mode
LED lit:
Tank is full
Button:
Toggle Power
Humidity or
Time Delay
Display