User guide
9
ENGLISHESPAÑOLFRANÇAIS
INSTALLATION INSTRUCTIONS
Carefully review all of these instructions BEFORE proceeding to install and operate your air conditioner unit. Fail-
ure to do so may cause damage, injury, or bodily harm including permanent disability and/or death.
LOCATION
• The air conditioner should be placed on a firm, level surface to minimize
noise and vibration. For safe and secure positioning, place the unit on a
smooth, level floor strong enough to support the unit.
• The unit has casters to aid in maneuverability, but it should only be
rolled on smooth, flat surfaces. Use caution when rolling on carpeted
surfaces. Do not attempt to roll the unit over objects.
• The unit must be placed within reach of a properly rated grounded socket.
• Never place any obstacles around the air inlet or outlet of the unit.
• Allow 1 to 3 feet (30cm to 100cm) of space from the wall for eicient
air-conditioning and to prevent overheating.
EXHAUST HOSE INSTALLATION
NOTE: For your unit to function properly, it is imperative that the exhaust
hose be vented to the outside when used in Auto, Cooling and dehumidify
modes.
1. Attach the adapters to the exhaust hose by snapping them in place as
shown in Figure B.
2. Insert the connector of the now-assembled exhaust hose into the hole
seat of the air outlet and slide the exhaust hose down along the arrow’s
direction as shown in Figure C. Pay attention to the tabs so that the con-
nector clicks into place.
The exhaust hose can be compressed or extended moderately according
to installation requirements, but it is preferable to shorten the hose to
desired length.
IMPORTANT: DO NOT OVER-BEND OR KINK THE EXHAUST HOSE.
(Figure D)
EXHAUST PORT
Make sure that there are no obstacles within 18” (50cm) around the exhaust outlet in order for the exhaust system
to work properly.
Fig. C
Fig. D
Fig. B
Fig. A
A - 12” - 39 ½” (30 CM - 100CM)
B - 12” (30 CM)
B
A
Exhaust hose
Exhaust hose
assembly
Unit Adapter Window Slider
Adapter